Acid-base modification is to use acid, alkali and other substances to treat activated carbon, according to the actual need to adjust the surface functional groups of activated carbon, make it change, improve its ability of adsorption of metal ions, so as to achieve the desired adsorption effect.Acid-base modification of activated carbon is usually carried out to improve the adsorption effect of activated carbon on metal ions represented by copper ions. The commonly used modifiers include HC1, NaOH and citrate 3.It was found that by acid-base modification of common coal activated carbon, the ash content of the activated carbon could be greatly reduced and the specPrinciple of activated carbon adsorption
activated carbon is a kind of very small granular has a large surface area, and more tiny holes in the granular - capillary. The capillary has very strong adsorption capacity, due to the granular surface area is large, so a good contact with with gas (impurities). When these gases (impurities) encounter capillary by adsorption, purification effect. Activated carbon surface area of the study is very important, only the BET specific surface area detecting data of active carbon method detected result is reliable, domestic at present there are many instruments can only make direct comparison method of detectionIn domestic has been eliminated. Specific surface area test unified the multi-point BET method at home and abroad, specific surface area measurement standards are developed at home and abroad is based on BET test method, please see our national standard (GB/T 19587-2004) - gas adsorption BET principle of solid material specific surface area measurement methods. Specific surface area testing is actually the more time-consuming jobs, as the adsorption capacity of sample is different, some sample testing may need to spend the whole dayTime, if the test process is not fully automated, the tester can not leave at any time, and should be highly focused, observe the dashboard, control the knob, a little careless will lead to the failure of the test process, which will waste a lot of valuable time of the tester.https://www.granular-activated-carbon.com/
F - Sorb 2400 specific surface tester is really able to BET method detection instruments (both direct comparison method), the more important F - Sorb 2400 specific surface tester is by far the only specific surface area of the fully automated intelligent testing equipment, the test results with the international high consistency, the stability is very good also, at the same time reduce the human error, improve accuracy test results.
The adsorption capacity of activated carbon on each gas (unit: mL /cm3):H2, O2, N2, CI2, CO2
4.5, 35, 11, 494, 97 The main factors affecting the adsorption of activated carbon ① the nature of activated carbon adsorbent
The larger the surface area, the stronger the adsorption capacity;
coal based activated carbon factory
Activated carbon is a non-polar molecule, easy to adsorb non-polar or very low polarity adsorbentific surface area of the activated carbon could be increasedactivated carbon pellets wholesale