Fir chip as the raw materials, H - POs as activator, using single factor analysis and orthogonal experimental design method, this paper discusses the influence granular activated carbon pore structure and the iodine adsorption value, methylene blue and strength of various preparation factors, determine the optimum process conditions of preparation of granular activated carbon phosphoric acid, phosphoric acid concentration is 70%, dipping 180%, kneading temperature is 170 ℃, for 60 min kneading time, activation temperature is 350 ℃, the activation time of 210 min.
The iodine adsorption value, methylene blue adsorption value, strength and BET specific surface area of GAC were 1020.04mGG, 225mg/g, 88.73% and 1486.48m2/g respectively.https://www.granular-activated-carbon.com/
The experimental results show that the impregnation ratio and carbon activation temperature have great effects on the adsorption performance of GAC, while the kneading temperature and impregnation ratio have great effects on the strength of GAC.
Because the strength of GAC decreases with the increase of impregnation ratio, and the decrease range is large, so the preparation of GAC with compound activator is proposed.
The results show that the composite activator can reduce the impregnation ratio of phosphoric acid to wood chips and improve the strength of granular activated carbon.coal based activated carbon factory
At the same time, the composite activator can improve the adsorption performance of GAC.
Therefore, granular activated carbon with good adsorption performance and high strength can be prepared by this method.